Z
OK! Been working on this a while... did it over several times and never get past this....
Go to EDIT/Groups/Group, carefully select the smaller pieces one at a time, If you select the wrong part, Hold Ctrl Down and click the wrong part again to deselect it. Press Enter when done.
Each time I added a part to the boat I joined them to that really the top is all one piece and the bottom is all one piece. I cannot figure out what the smaller pieces are you are referring too. Probably obvious once you tell me
Pretty cool using the mirror and stuff!
Oh yeah - this line:
Now, put ORTHO on and drag the Yellow model so that both transoms line up
I couldnt find where I should have turned it off (Unless this was a reminder just to make sure it was on!)
Great stuff here Zathros - might make a model someday! Oh wait I am already with your help
Chris
Actually, if I remember correctly, there's already a thread on here explaining how to design in Rhino using a 3-view. I read it a long time ago, and follow it pretty much step by step every time.
But I think I will do a thread on how I design. I've gotten a few questions on how to do it anyway.