In the book it says to test the train in DC to see if it runs properly.
A train that runs well in DC should run excellent in DCC
(Its a DCC equipped atlas loco)
Should I just get 2 wires and hold it to my track from my old DC pack and see how my new train runs?
I wont want to solder anyway just for analog testing.
I dont know anything about electricity but THere isnt enough electricity to get electricuted right? lol...
Is there any problems with just holding the wires to the track?
A train that runs well in DC should run excellent in DCC
(Its a DCC equipped atlas loco)
Should I just get 2 wires and hold it to my track from my old DC pack and see how my new train runs?
I wont want to solder anyway just for analog testing.
I dont know anything about electricity but THere isnt enough electricity to get electricuted right? lol...
Is there any problems with just holding the wires to the track?