Hi !
I am confused about my new P2K BL-2 locomotive.
My understanding is that this new loco is DCC ready, but I don't see a chip plug when I open her up. Where I think the plug should be, there is just what looks like an up-side-down circuit board (several solder cones up).
I called Life-Like - but no one was there that could answer my questions!
The loco also seems to have less power (and dimmer lights) than my other models (Atlas, Stewart and Athearn). Great detail, though! Does anyone else have this model and these problems ??? Or, if not, have some ideas ?????
I would appreciate any feedback you have on these problems!
This is my first P2K - a bit disappointing at this point. :-(
Thanks in advance !!!
I am confused about my new P2K BL-2 locomotive.
My understanding is that this new loco is DCC ready, but I don't see a chip plug when I open her up. Where I think the plug should be, there is just what looks like an up-side-down circuit board (several solder cones up).
I called Life-Like - but no one was there that could answer my questions!
The loco also seems to have less power (and dimmer lights) than my other models (Atlas, Stewart and Athearn). Great detail, though! Does anyone else have this model and these problems ??? Or, if not, have some ideas ?????
I would appreciate any feedback you have on these problems!
This is my first P2K - a bit disappointing at this point. :-(
Thanks in advance !!!