Toutenkarton
Active Member 57 From France Alsace
Latest activity Postings Media About
-
-
Here are the images from my first UHU02 Tie interceptor wing build.You can see the dufference in the detailings. -
The small details for the inside of the wing are done. I will look if I can find a image from the original UHU wing to compare. Next...
-
Rear details done. Next the details that goes on the sphere.
-
At first I wondered: "Since when does a TIE fighter have round wings?" :hammerhead: This post leads to several conclusions: 1) This...
-
Yeah the wings are ready. Now I can start adding the inner and outside parts. But here is the wing without any add ons.
-
Toutenkarton reacted to Rhaven Blaack's post in the thread Battlestar Galactica/Buck Rogers Hover Vehicle with
Love.
Here is a quick video showing the Hover Vehicle (*NOTE* I used two paper clips to hold up the vehicle, so that you can see the... -
Toutenkarton reacted to Rhaven Blaack's post in the thread Battlestar Galactica/Buck Rogers Hover Vehicle with Love.
Here are the parts for the "hover" mechanisms. I attached the base plate in place. The outside of the "skirt" is applied. The...
-
Toutenkarton reacted to Rhaven Blaack's post in the thread Battlestar Galactica/Buck Rogers Hover Vehicle with Love.
Here are the parts for the "propulsion units". The "propulsion units" are assembled. The "propulsion units" are attached in place...
-
Toutenkarton reacted to Rhaven Blaack's post in the thread Battlestar Galactica/Buck Rogers Hover Vehicle with Love.
Here are the parts for the "energy packs" and the intake system. The "energy packs" are assembled. There are four for each side. The...
-
Thank you. Progress on the wing is slow big parts to glue and to dry.
-
Toutenkarton replied to the thread New template Tie Interceptor.weren't you heavier?:laughrolling::laughrolling::laughrolling:
-
My setup for constructing the wings. I already cut, glue and cut the solar panels and the panel frames. I think I can assemble these on...
-
Toutenkarton reacted to Rhaven Blaack's post in the thread Battlestar Galactica/Buck Rogers Hover Vehicle with Love.
@Revell-Fan and I were discussing ideas to improve the spoiler/trunk lid. This is the initial idea that I came up with and am presenting...
-
Toutenkarton reacted to Rhaven Blaack's post in the thread Battlestar Galactica/Buck Rogers Hover Vehicle with Love.
Here are the parts for the operator's cabin frame, control console, and steering wheel. The operator's cabin frame, control console...
-
Toutenkarton reacted to Rhaven Blaack's post in the thread Battlestar Galactica/Buck Rogers Hover Vehicle with Love.
Here are the internal formers. The internal formers are assembled. The internal formers are put into place (but sit freely, without...
-
-
Loading…
-
Loading…
-
Loading…