Viper Car, by @Revell Fan.

[micahrogers]

The rear plate installed, while I could reach it...


Left engine tube with wing installed.


and the right.


I mixed my dark grey paint with Aleene's Tacky glue to glue the tubes down, and seal the gaps... and didn't realize I had some on my finger, so now I have an 'oil' smudge on the left tube...

Ohh well.

 

[Awry_Chaos]

The rear plate installed, while I could reach it...
View attachment 200187

Left engine tube with wing installed.
View attachment 200188

and the right.
View attachment 200189

I mixed my dark grey paint with Aleene's Tacky glue to glue the tubes down, and seal the gaps... and didn't realize I had some on my finger, so now I have an 'oil' smudge on the left tube...

Ohh well.

The 'oil' smudge adds character to the model! Couldn't have done better myself. You're a master!

 

[micahrogers]

The 'oil' smudge adds character to the model! Couldn't have done better myself. You're a master!

Thank you, I needed that laugh.

 

[Revell-Fan]

I agree! It only adds to the look!

 

[micahrogers]

the upper engine mounts created.


Greebelies added.


And edge colored.

 

[micahrogers]

and the upper engine tube installed....

 

[Awry_Chaos]

and the upper engine tube installed.... View attachment 200269View attachment 200270View attachment 200271View attachment 200272

Looks really nice! Can't tell that you made any mistakes! Great work so far!

 

[Revell-Fan]

YES! The alignment is spot-on!

 

[mijob]

Verry, verry nice

 

[micahrogers]

The top fin may be a few arc seconds off, but without offset squares, who would know...

 

[micahrogers]

I'll get started applying the rest of the greebelies today... then on to the wheels.

 

[Revell-Fan]

The top fin may be a few arc seconds off, but without offset squares, who would know...

You never know what this car has gone through on the road.

 

[micahrogers]

I got all the greebelies on tha engine section,



Now tomorrow I start on the wheels...

 

[Awry_Chaos]

EXCELLENT!!!

 

[micahrogers]

A new, relatively cheap, $7.00 USD, knife to try out.


Fiskars finger loop knife, it uses #11 blades, and should be easier to control.

 

[Awry_Chaos]

A new, relatively cheap, $7.00 USD, knife to try out.
View attachment 200327

Fiskars finger loop knife, it uses #11 blades, and should be easier to control.

Looks interesting!

 

[Revell-Fan]

Ohhh, nice!

 

[ennder]

I've used one for about 10 years..... I like it better then the original handles.
Even if you don't put your finger through the hole.... it's still easier to hold on to.

 

[micahrogers]

Believe it or not, I had no idea this existed until I saw it showcased on Adam Savage Tested's Youtube channel. It is the favorite knife of thier resident papercrafter, I don't remember her name, but she dose amazing paper stuff for props and art projects.

 

[Rhaven Blaack]

A new, relatively cheap, $7.00 USD, knife to try out.
View attachment 200327

Fiskars finger loop knife, it uses #11 blades, and should be easier to control.

I have one of these. They are good for precision work.