And for my next creation....
- Thread starter Cybergrinder
- Start date
- Apr 5, 2013
- 13,876
- 10,216
- 228
It's been delayed a bit due to work, but here's the underside of the hull complete
View attachment 170522
Still to be greebled....
That section really came out great!! If I didn't know where the seams were, I wouldn't see them.
It's been delayed a bit due to work, but here's the underside of the hull complete
View attachment 170522
Still to be greebled....
Looks great!
rinks: Looking forward to the greebles!
Sky Seeker
:Viper:
What I have been doing is working on the top section of the secondary hull so I can figure out the alignment & cuts required for the supports & wiring. Pic coming soon! Then I'll greeble the bottom section (not much on the top)
After that I'll join the nacelles....
Going to need more clear LED's for the saucer....
After that I'll join the nacelles....
Going to need more clear LED's for the saucer....
Here we go, top of the secondary hull!
80's lego guy approves!
80's lego guy approves!
Shuttle bay attached
And now, the moment of truth, attaching the wings and nacelles. Nacelles not attached yet
And now, the moment of truth, attaching the wings and nacelles. Nacelles not attached yet
And here they are....
attached!
Wiring and gaps to be completed
attached!
Wiring and gaps to be completed
- Apr 5, 2013
- 13,876
- 10,216
- 228
In terms of quality of construction, I think this is your best model yet!! It looks excellent!!!
And here they are....
attached!
View attachment 170641 View attachment 170642
Wiring and gaps to be completed
You nailed those nacelles! Great job!
rinks:rinks:rinks:Looking forward to seeing them lit up.
Sky Seeker
:Viper:
@Sky Seeker , there is a post earlier in the thread with them lit up
I need to do the wiring before anymore lighting photos as the supply is entering via the nacelles, each nacelle carries the seperate polarities.
I need to do the wiring before anymore lighting photos as the supply is entering via the nacelles, each nacelle carries the seperate polarities.
Now, who's for some tea?
Yes, I've started on the saucer section.
Underside
And the supports
Yes, I've started on the saucer section.
Underside
And the supports
- Apr 5, 2013
- 13,876
- 10,216
- 228
Those formers aren't glued down in that pic, are they? Also, in real aircraft, to make formers stick to compound surfaces, the binding agent is a very thick, think, "thick peanut butter, no nuts" as gooped on around an inch thick and wide. This holds the composite surface to the formers, and takes up any difference in shape. Think compound curve saucer, straight edged top of former. Put some longitudinal formers to make the framework even on both sides. You will have a very strong saucer section. Looking really good.
Formers not glued down
that was just a test "fit"
Another test fit with the formers for the underside. I can see a challenge getting the lighting right for some of the windows....
I'll figure it out though!
that was just a test "fit"
Another test fit with the formers for the underside. I can see a challenge getting the lighting right for some of the windows....
I'll figure it out though!
Last edited:
Good news, I figured out how to do the lighting
Lots of chopping to the saucer base required for the LEDs and some delicate surgery to the B former...
Lots of chopping to the saucer base required for the LEDs and some delicate surgery to the B former...
- Apr 5, 2013
- 13,876
- 10,216
- 228