I then continued adding strength to the parts as I cut them, I even tried some of this corrugated card. I also printed parts twice to glue onto card stock for cutting of the reinforcement, wont do that again, not very cost affective
I haven't experienced any upload problems. The picture is placed where you put the cursor and click./ If it has not finished uploading, it will grab the picture that has uploaded and put it in that spot. It's best to upload all your pictures, then go back into the thread and place pictures were you want.
Tahts it. I'm not sure whats going on the pictures just wont upload properly. Good time to remind people to back up required photos, as I did not and have lost over half.
Great to hear that you have fixed the issue. Since I have updated from Win 8 to 10 I have to switch browsers to upload anything on zealot. Firefox does not work (I have no clue why) but Chrome does.