Running Atlas Loco's with Bachman EZ command

Discussion in 'DCC & Electronics' started by railman537, Nov 22, 2006.

  1. railman537

    railman537 New Member

    Joined:
    Oct 23, 2006
    Messages:
    8
    Likes Received:
    0
    Got a real nice Atlas loco i'd like to run on my dcc layout. I already moved the jumper on the dual mode decoder to use DCC. It seems the loco is preprogrammed to last 2 numbers of road # which is 25. EZ command only uses 10 addresses. What are my options?
  2. oldtanker

    oldtanker Member

    Joined:
    Feb 24, 2006
    Messages:
    830
    Likes Received:
    0
    Reprogram as per the instructions that came with your controller. Be sure to use the resistor listed for a programing track.

    Rick
  3. MilesWestern

    MilesWestern Active Member

    Joined:
    Sep 21, 2005
    Messages:
    1,905
    Likes Received:
    0
    Also, as far as the number, make it "5" the last number in your address.
  4. EngineerKyle

    EngineerKyle Member

    Joined:
    Oct 3, 2005
    Messages:
    468
    Likes Received:
    0
    Yah, and you don't need a programming track, for that matter.

    Just remove the other locos from the track you're programming on... or they'll all be "5"