I downloaded a model of a figure of a girl that is dressed up to look like an F-14. After some searching I finally figured out that I needed pepakura to look at it, so i downloaded that and all was well. I go to print it today and find out that it is on larger than letter sized paper :evil: Since my printer can NOT handel anything larger than letter sized paper I need to know if there is any way that I can actually print this model. It is a really nice model so I was printing on really nice photo paper to get the proper finish and now I have one page that has the two parts at the bottom not complete. Luckily I did only print out one page and not all at once.
Anyways Just need to know if there is anyway to maybe export the pages of parts from pepakura to my imaging software to rearrange the parts so that I can actually build this model.
Thanks for listening to me whine and any help (even the negative kind) will be appreciated greatly.
Kevin
P.S. sorry if this is in the wrong place let me know and ill delete and repost it where it belongs or if need be i wont mind if it is moved to its proper location. Thanks again
Anyways Just need to know if there is anyway to maybe export the pages of parts from pepakura to my imaging software to rearrange the parts so that I can actually build this model.
Thanks for listening to me whine and any help (even the negative kind) will be appreciated greatly.
Kevin
P.S. sorry if this is in the wrong place let me know and ill delete and repost it where it belongs or if need be i wont mind if it is moved to its proper location. Thanks again