Hello all,
I am installing a Digitrax decoder in my Athearn sd40-2.
I was trying to wire in a new headlight set up using 2 12volt Microlamps from RadioShack. These have 60mA. So I am using a 22K Ohm resistor like the Digitrax book says to use w/any bulb over 50mA. The bulb will light w/o the resistor but it will not w/the resistor after the resistor has been soldered.
Jaijef
Any help is appreciated.
sincerely
jaijef
I am installing a Digitrax decoder in my Athearn sd40-2.
I was trying to wire in a new headlight set up using 2 12volt Microlamps from RadioShack. These have 60mA. So I am using a 22K Ohm resistor like the Digitrax book says to use w/any bulb over 50mA. The bulb will light w/o the resistor but it will not w/the resistor after the resistor has been soldered.
Jaijef
Any help is appreciated.
sincerely
jaijef