Hey all,
I've been digging through the forums and my DCC books and I must be totally missing something here. My turnout (only 1 connected atm) isn't working.
Here's a quick rundown.
I've got Digitrax DCS100 with a power bus running under the table. I've got a 4 track feeders so far tapped in.
I also have one feeder running to Atlas remote turnout switches with one switch connected now. When I try to through the switch, all I get a little buzz from the switch motor.
I'm guessing it's either under powered or over powered and I should probably use a seperate power supply just for the turnout controls, but no idea what I should be using for it.
I'm gonna keep reading around but any assistance would be appreciated.
Thanks.
I've been digging through the forums and my DCC books and I must be totally missing something here. My turnout (only 1 connected atm) isn't working.
Here's a quick rundown.
I've got Digitrax DCS100 with a power bus running under the table. I've got a 4 track feeders so far tapped in.
I also have one feeder running to Atlas remote turnout switches with one switch connected now. When I try to through the switch, all I get a little buzz from the switch motor.
I'm guessing it's either under powered or over powered and I should probably use a seperate power supply just for the turnout controls, but no idea what I should be using for it.
I'm gonna keep reading around but any assistance would be appreciated.
Thanks.