Dave, looks very good.
I tested an other method and I was shipwrecked.
Fence was a very thin meshed metal baffle. I have set metal posts and I tried to fix the meshed metal to the post by an upper and a lower extra thin steel guy wire. I would give the meshed metal by these wires a good stability. But it did not work.
The thin wires were pulled through the meshes however with tightening the wires I have got small loops which worked like fine hooks. So I did not get a tight fence but the meshes were destroyed by the loops and all was not more than a huddle of scrap. The reason for my mistake was the very thin guy wire and a too fine meshed metal.
I think you could get a better impression yet if you will add a very thin twine pulled through the meshes near the ground of your fence and turn twice the twine around the posts. I think that you can get a bit more stability and you can pull down the fence to ground at the posts in order to get a more tightened fence, especially in upright direction.
But I'm sure also that this will be a difficult work.
Let see us your next steps.