Im building mybasic layout from an article I saw in the new model railroader mag, but they do some things in there I dont get. They say to build the benckwork and table from ripped 3 inch strips of 1/2 plywood, that doesnt make sense to me. Why go to trouble of ripping a 4x8 sheet of plywood, on a itty bitty home table saw, when you can just use 1x3 solid lumber, which to me would be easier, cheaper, stronger and better looking, or is there something to this I dont know about?
they say to use contact cement to glue down your grass mat, does anyone have another option?.....contact cement is a one time only chance, you screw it up, and you just blew a good chunk of cash......
how do you make roadbed material curve? Im using the foam roadbed, and if you give a little stretch it will follow curves, but how do you keep it that way until the glue sets up? any tips?
anyone have a basic DC wiring diagram?
that is all for the moment trust me there will be more, thanks!
they say to use contact cement to glue down your grass mat, does anyone have another option?.....contact cement is a one time only chance, you screw it up, and you just blew a good chunk of cash......
how do you make roadbed material curve? Im using the foam roadbed, and if you give a little stretch it will follow curves, but how do you keep it that way until the glue sets up? any tips?
anyone have a basic DC wiring diagram?
that is all for the moment trust me there will be more, thanks!