Sorry for the lack of pictures so far, I can't get my computer to pull them off the camera.
Construction is currently nearing completion, the vertical stabilizer is nearly complete, and should be attached later today. Then I'll assemble the canopy (I'm going to try to use plastic sheet).
Since I elected not to attach the landing gear (I prefer "in-flight" models), I'll construct them separately to test them out. I've been debating modifications to allow folding gear instead, but I'll have to assemble them normally first.
Construction so far is going well, the parts fit as they should. Some techniques could be suggested in the instructions to make assembly easier, steps that the parts allow for easily (like constructing an entire wing before attaching it at the root).
I haven't looked at the new instructions yet, but I hope they include the minor pieces (landing lights, etc) since these were a mystery to me for awhile until I figured out what they were for.
Once again, my fingers are not as accurate as I'd like, and the model is a little sloppy, I'll probably cover it with re-prints on normal paper, to make everything look better.
Construction is currently nearing completion, the vertical stabilizer is nearly complete, and should be attached later today. Then I'll assemble the canopy (I'm going to try to use plastic sheet).
Since I elected not to attach the landing gear (I prefer "in-flight" models), I'll construct them separately to test them out. I've been debating modifications to allow folding gear instead, but I'll have to assemble them normally first.
Construction so far is going well, the parts fit as they should. Some techniques could be suggested in the instructions to make assembly easier, steps that the parts allow for easily (like constructing an entire wing before attaching it at the root).
I haven't looked at the new instructions yet, but I hope they include the minor pieces (landing lights, etc) since these were a mystery to me for awhile until I figured out what they were for.
Once again, my fingers are not as accurate as I'd like, and the model is a little sloppy, I'll probably cover it with re-prints on normal paper, to make everything look better.