I'm interested in building Battlestar Galactica ship. Below I listed all paper models of this ship which I found:
Original series (TOS) (1978-80)
1. http://jleslie48.com/bg/index.html - free for download from site. Textures are based on this model: http://www.cloudster.com/Sets&Vehicles/Galactica/CrevelingGalactica/GalacticaCreveling.htm#Creveling. A bit less than 120 parts (if I did not miscount). Quite detailed instruction.
New series (TNS) (2003-...)
2. http://www.freewebs.com/jaybats/cardiscontact.htm - As far as I can see on pictures it can retract/extend landing bays (http://www.freewebs.com/jaybats/apps/photos/photo?photoid=42824887 & http://www.freewebs.com/jaybats/apps/photos/photo?photoid=42824888) or those are two models.... Download from site is not available (at far as I know) but it is possible to get it from download section on this forum. As described on Jay's site it has mirrored textures, so names on one side are also mirrored.
3. http://stevespaper.com/?page_id=66 - two Galacticas 1,5 ft (about 0,5 m) and 3 ft (about 1 m) long. Based on Coxxon 3D models. Looks like this one is the most detailed version of all.
I'm interested in third one. On Steve's site is written: "Regardless of which you choose you’ll need the assembly instructions." I was trying to found them, but no luck. I found Rhaven's thread which partially covers assembly. Are there any instructions for this model or I need to use my intuition?
Original series (TOS) (1978-80)
1. http://jleslie48.com/bg/index.html - free for download from site. Textures are based on this model: http://www.cloudster.com/Sets&Vehicles/Galactica/CrevelingGalactica/GalacticaCreveling.htm#Creveling. A bit less than 120 parts (if I did not miscount). Quite detailed instruction.
New series (TNS) (2003-...)
2. http://www.freewebs.com/jaybats/cardiscontact.htm - As far as I can see on pictures it can retract/extend landing bays (http://www.freewebs.com/jaybats/apps/photos/photo?photoid=42824887 & http://www.freewebs.com/jaybats/apps/photos/photo?photoid=42824888) or those are two models.... Download from site is not available (at far as I know) but it is possible to get it from download section on this forum. As described on Jay's site it has mirrored textures, so names on one side are also mirrored.
3. http://stevespaper.com/?page_id=66 - two Galacticas 1,5 ft (about 0,5 m) and 3 ft (about 1 m) long. Based on Coxxon 3D models. Looks like this one is the most detailed version of all.
I'm interested in third one. On Steve's site is written: "Regardless of which you choose you’ll need the assembly instructions." I was trying to found them, but no luck. I found Rhaven's thread which partially covers assembly. Are there any instructions for this model or I need to use my intuition?