Me-109 G2 1:33 Orlik

Status
Not open for further replies.
josve

josve

Senior Member
Oct 21, 2005
620
579
111
62
Odda Norway
I have now decided to start to build a plane.
I choose the Me109 G2 from Orlik since it's an fairly easy aircraft to start with and the constructor is well known for his good fit.I hope you're not fed up with the Me's.....


I started with the cockpit as I have seen most builders do :)

Here I have put together the main cockpit construction


And started with the interior.....as you can see I added some dirt at the rear end :)
 
Some further progress on the inside was done before my lateshift today.

The pilots seat


Seatbelts


And the pedals
 
Today I made the trim wheel,control stick and the instrument panel.
Just a few "rivets" missing on the stab trimwheels

 
Made the side panels


The left panel installed


Then I put on the first skin


And started the preparation for the front part with the guns
 
Looks awesome Johnny! Not gonna put little bottons on the sides of the seat? :D
Chris
 
In your dreams Chris!!
I know I sometimes might overdoe some detailing, but even I have some limits :)

I take this build as a learning build,so I'm not expecting the final result to be very good.But so far I think most of it has gone ok. I have done some errors,but nothing much to speak of.I'm just to hasty.....
 
Paint is something I have problems with because of my colorblindness.....
Here is my solution :)

This is 2 liters of paint......I need a teaspoon :)

So over to the plane!
Dryfitting the part after shaping, and I made some connection strips on the inside of each section to be sure it stayed together.


The cover under the cowling


I also made some new machineguns with a barrel this time :)


I also skinned the centerpart of the wings.
 
Status
Not open for further replies.
Top Bottom