lights

  • Thread starter Thread starter lester perry
  • Start date Start date
L

lester perry

I usually get decoders from one shop. But a shop closer to home has started carrying DCC but he is not very knowledgeable. The first shop supplied resistor for lights the new one doesn’t. I need to know what to get for the lights to get from 12v to 1.5v , a radio shack number would be nice as I know very little about electronics,
Les
 
If no one else replies with an answer to your dilemma, PM Woodone. He would more than likely be able to help you with that.
 
Or do what I do: I have resistor values on hand in increments of about 100 ohms, starting near 60 and up to 1100. I start at the high end and work my way down, using whatever value lights the bulb.
 
I think I found it in doing some reading, I came up with 1 ohm. Hope this is right
Les
 
1 Ohm is NOT correct. That will either fry the decoder, the light, or heat the resistor up so much you melt the loco. You should be using something like 1k(1,000) ohm 1/4 watt resistor.
 
Not 1 Ohm!!!!!

1 ohm will not work-- a blown light bulb for sure. :eek:
1k (or 1000 ohm) a good place to start- I would think that 750ohm would do the trick.
The new book on DCC has a chart on resistor valuues for DCC.
 
VOLTS and AMPS

To get the proper resistor for your lights you will need to know the voltage of the light and the amount of current that it draws. Most likley will be in milliamps for the current draw. Like 15MA or could be 60MA.
You could hook up a 1.5 volt battery to the bulb and hook up a multimeter inline to read the milliamps. That way you would know what kind of amps the bulb is using.
What we are doing is to use Ohm's law--R=E divided by I or I =E divided by R or E= IR
R is resistance I is current and E is volts
Hope this migh help
 
Well I just bought some 1k ohm resistors at Radio shack. I will give them a try and let you know how it works
 
You must log in or register to reply here.
Top Bottom