Liberty Prime from Fallout

daishi

Well-Known Member
Finally finished my Liberty Prime proxy for Fallout: Wasteland Warfare.this was about a 4 months project all in all.

Printed on my Ender 3 using PLA, 0.2mm nozzle/0.8mm layer height.
Separated into 10 parts (- the Power Armored BoS knight), and took about 20 days (480 hours) to print.
The base is 175 mm wide, the whole model is about 26cmm tall.

After assembly, and adding baking soda for sand:
LP_01.jpg LP_02.jpg
After base coating:
LP_03.jpg

Mostly painted:
Used dry brushed silver on a black base for an old beat-up metal effect (Citadel Necron Compound), and a corrosion technical paint + rust drybrush for the overall weathered look. Paints are acrylics.
LP_04.jpg LP_05.jpg LP_06.jpg LP_07.jpg LP_08.jpg LP_09.jpg
LP_11.jpg LP_12.jpg LP_14.jpg LP_13.jpg LP_10.jpg

And finally in its display case on my office desk.
The band with the golden text was printed as well.
I've also added a Brotherhood of Steel Knight for scale and because the base looked a bit empty without something there. :D
LP_15.jpg LP_16.jpg LP_17.jpg
 
Last edited:

zathros

*****SENIOR ADMINISTRATOR*****
Staff member
Administrator
Moderator
That's a lot of nail biting time, that much plastic could get hot!! IT came out great!! :)
 

bigpetr

Designer/Master Modeler
Realy nice print and paint job. Knight for scale is a good touch. It is allways good to have something that hints the scale.
 
Top