Think I have too much time on my hands - started making little people for my Santa Fe Valley Line passenger cars. Bought a pack of sitting people and thought I would try and duplicate a few, ya like - maybe a couple of hundred. Only have to mold half people as this is all that is visable through the window of the car. The picture is how I made the mold of my half people. It's a mess because I had just broken the side of the box to remove the rubber mold. Think you will get the idea of how I did it, lined the bottom of a plastic box with modeling clay and pushed the people in half way. Made a mold for 1/2 people left and right sides. Made a clay sprue, not for pouring the plastic but rather for a way to hold the little suckers for painting. Covered the molding material I used in a previous post. (Micro Mark RTV and 10 minute cure plastic.)