No, that's an Atlas through girder bridge that I cut the floor out of, then used some styrene to make an interior framework. I used Micro Engineering bridge tie strips to finish it off. The bridge is five spans in total .
Here's the same end of the bridge, looking the opposite way as the first photo: from the bank, modified Atlas through girder, Central Valley Pratt truss,
then another modified Atlas girder, followed by a Micro Engineering 50' deck girder,
and ending with a Micro Engineering 30' deck girder, which is barely visible among the bushes. (the loco is on the 50' ME girder shown in the previous picture)
Wayne
Here's the same end of the bridge, looking the opposite way as the first photo: from the bank, modified Atlas through girder, Central Valley Pratt truss,
then another modified Atlas girder, followed by a Micro Engineering 50' deck girder,
and ending with a Micro Engineering 30' deck girder, which is barely visible among the bushes. (the loco is on the 50' ME girder shown in the previous picture)
Wayne