Star Wars A-wing / Shunichi Makino + heavy mods/ 1:48
- Thread starter bigpetr
- Start date
Details at the back are completly finished. I am quite happy with it. Photos are great for showing flaws in edge coloring. I will addres this issues some more. Now I need to think about what to do next. Probably details at top and bottom, then cokpit and vertical stabilizers with engine rings last.
Everything is so very clear, clean and crisp! You are doing a FANTASTIC JOB!!!
Without a doubt, the best A-Wing I've seen. Better than the plastic kit I built ages ago. 
Here is size comparision of A-wing and X-wing:
Here is size comparison of Tie-fighter wing test print with X-wing. Back is fast Snowspeeder texture test model to see how it will look together with the rest:
Here is size comparison of Tie-fighter wing test print with X-wing. Back is fast Snowspeeder texture test model to see how it will look together with the rest:
Curent official length is 6.9m.
I calculated mine to be 6.6m. I did my size calculation based on this original movie model:
and this matepainting:
And in this size and speed comparison chart from the movie SFX team A wing is even smaller than mine:
I calculated mine to be 6.6m. I did my size calculation based on this original movie model:
and this matepainting:
And in this size and speed comparison chart from the movie SFX team A wing is even smaller than mine:
Sweet! When you're a kid everything looks bigger!
The Battle at Endor was my favorite, especially after I read the background information about it in the Extended Universe.
The Battle at Endor was my favorite, especially after I read the background information about it in the Extended Universe.
This comparison shot is jaw-dropping!!! You are truly a master, @bigpetr ! 