curved roof
The curved sides were made by tracing a pattern onto really thick styrene and cutting 2 identical pieces. Then after they were braced across every few inches with plastic beams from plastruct, I took a long thin piece of styrene sheet and CA glued it gradually until it was secure. I had to glue it a couple inches at a time before it was finished. I cut some thin evergreen styrene strips to give it texture, primed with grey primer, painted with spray can, and dullcoted it. It is my largest scratch built project, and I'm happy with it. That Mills bros lumber is a fantastic kit, why does Walthers have to retire it?