Mandalorian and Elf

Sudsy

Well-Known Member
Took a break from building this weekend to paint up a couple of 3D printed busts. Both were supportless models printed at .05 mm on my modified Lulzbot Taz 5 with Matter Hackers Build PLA. Primed, and painted with Army Painter Speed Paints and then regular acrylics.

First off is the supportless Elf Archer I found on Thingiverse:
EA FRONT 2.jpgEA FRONT.jpgEA Left.jpgView attachment 215622View attachment 215623

Next is the supportless Mandalorian I found, sadly, I don't have a link for this one... I tried searching again, and it's lost in the THOUSANDS lying about there!

MANDO FRONT 2.jpgMANDO FRONT.jpgMANDO LEFT.jpgMANDO RIGHT.jpg
 

Attachments

  • MANDO REAR.jpg
    MANDO REAR.jpg
    612.7 KB · Views: 0
Top