You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
I'm new to DCC and believe I just destroyed my Digitrax DH163 decoder by trying to program it while I was running the loco. Is this a major "no-no" with DCC? It had been doing fine until I decided to be a little adventurous by changing the acceleration and decel rates while I was running the loco. About 5 minutes into this, the locomotive stopped and all I can see now is the rear light on when I power on. I seem to still be able to read my CVs and tried resetting the decoder multiple times with no results. Nothing seemed warm to touch, but I can't think of any other explanation. Please advise. Thank you!