Search results

Sorry Bazooka Joe :cry:found this picture on my hard drive when I was doing some clean up thought that I would throw it in to show that your work is top :twisted: notch. The Neck brace went together real good :thumb: it left me wanting to get more.

I have been real busy with car's breaking down etc.... so it has been difficult getting time to work on this but did had some time tonight. After cutting the parts out and carefully dragging the knife across the tab to peel up just the foil off of the tab so that I have a clean paper surface to...

This looks cool. Dont forget the scar on the left side of Hell boys face just under his eye.

BazookaJo and Ekuth are working hard at making the Cylon Armour for all of us.:thumb: He (BazookaJo) did an exelent job making the Cylon helment, and has alowed me to have a ceta build of the Neck brace that he is working on. I have started building it, buy printing it on normal print paper and...

I Want I Want Now Im Realy dying to build these two Models!!!! the wait is Killing me.:killer:

ceta build I woulod like to take part in the ceta build for your Hell boy:wave:. also how is the neckbrace going for the cylon helment.:mrgreen: doo you have any pictures yet.

polished Well it shows that I need to go back and do some additional sanding to get the finish that I want, but it will do for now.

Ready to buff Well it looks like all the sanding is done and ready to polish.:-D There are a few spots that I couldn't get to so I will have to live with them.:( This will be my first time at polishing Aluminum so cross fingers and hope for the best. The next thing this build will need is...

yes i would like to have a copy of your circuit diagram for when i complete the metal build.8) did you build this with transistor or solid state? Just a little more sanding to do.:twisted: This has turnd out to be more work then it sounds.:shock:

Well so far all I have shown is the front and side of the helmet so here is the back, bottom, side with a little sandingand the start of the back plates.

weld I’m not sure :? if I should make the back of the helmet with black window mesh or aluminum plate and then paint it.8) or make it so I can swap it out.

weld Well I have got a little more welding to do, and I still need to make the back of the helmet.8) I just made and tacked in the mouth pieces today.8) And I thought Id show how it looks so far.

Red lens What about using a transparence sheet for the printer and print dark red. Could go with two layers thick and it should give close to the effect that you want with the bright LED’S As for the line of sight the acttors had to look out though the little holes above the red eye. This...