new info,
tried running it in one place and noticed the following.
stops then restarts after several minutes. slows down and speeds up.
I ran it in one place with a tack in from of it so it cant move.
strange :)
Craig
hi All,
I hope someone can help me. I have a atlas loco class b23-7 which is running strange. when I run it it doesn't always move but if it does and i run it at any speed it will start at this speed and then it starts to slow down and speed up and finally stops. It can't be the track as...
hi all,
dont know if this is the right place to post but here goes.
Attached is a basic idea for a section of my layout. part of this section is a reverse loop and part siding industry track etc.
My question is do i have to include all the track in the reverse loop and there for...
hi,
A question About dog bone layouts and reverse loops
attached is an idea i have for my layout. my question is can I have the crossover and use a reversing loop controller if i isolate the whole section from the crossover left? I hope this makes sense.
Thanks
Craig
serial cable wire is like wire in usb and network cables. I wondered as sometimes my loco's take a while to respond. Looks Like time for a rewire:thumb:
Thanks For the info.
Craig
hi,
a question about wire thickness, does the thickness of the wire effect proformance?
As i have wired my layout using wire from computer serial cables, or should I change to thicker wire.
thanks
Craig
Hi ALL
Hi all and thanks for all the feedback !:)
I think I will go with the cassette as I have room for it on a staging area and I like I idea about using a small cassette for the loco ! I hadn't thought of using one :thumb:
Thanks Everyone !!
Sirrab
Hi All :)
I don't know if this is the right section to post in but here goes !
I need to turn trains on my layout but I don't have room for a reversing loop or a wye.
Does any one have any idea's?
I was think of using a turn table? has anyone done it or able to give me a link to one...
Hi All,
Can soneone tell me how you change couplers on loco's or does it depend on the loco. I have a Bachmann U36B and I brought a atlas flat car that doesn't have the ugly rapido couplers on it. I want to change all my rolling stock but the loco doesn't seam so easy.
Thanks
Craig