yokomo drifter

Discussion in 'RC Drifting and Setup' started by herzog racing, May 7, 2005.

  1. herzog racing

    herzog racing New Member

    Joined:
    Feb 27, 2005
    Messages:
    12
    Likes Received:
    0
    I just got my yokomo drifter today and the screws keep striping and it seems hard to tighten them. I have all ready done with half the kit and I want to run it realy soon. should I replace the ball studs on it to titanium.
  2. SpArKeY_STi

    SpArKeY_STi Member

    Joined:
    Jun 4, 2004
    Messages:
    808
    Likes Received:
    0
    sounds like your stripping them yourself, overtigtening them. It has a plastic chassis, so you need to be REAL careful. Use nail polish (unless you dont have some) then use locktight, and screw them in that way, lightly untill they give more pressure then normal

    And with ball studs, its good to put a nut on the other side.