I am building Funaro & Camerlengo's kit #6220 - Rutland Hopper Bottom Coal Car. The kit comes with about 2 dozen parts for the brake system, but absolutely no instructions...not even a diagram showing the assembled system. Also, there are no detailed instructions for the installation of the queen posts and truss rods. F & C assumes the modeler knows this stuff and this modeler doesn't. I need an under-car diagram showing the brake system, queen posts and truss rods. Thanks.
Modeling a brake system
- Thread starter GYurick
- Start date
GYurick,
It may be better to keep your questions in one place for ease of you following up, and also easier to reply and follow things up just in the one place.
Perhaps we could use you question in "Technical Q & A" to keep all the answers and help in.
BTW..... I can't help you out on this one..... other than "make it up"! Be your own brak system designer! Most of have had to "freehand" at some stage!
It may be better to keep your questions in one place for ease of you following up, and also easier to reply and follow things up just in the one place.
Perhaps we could use you question in "Technical Q & A" to keep all the answers and help in.
BTW..... I can't help you out on this one..... other than "make it up"! Be your own brak system designer! Most of have had to "freehand" at some stage!