HSP Sonic 1/10th 2 spd nitro

Discussion in 'RC Onroad Forum' started by Nungy, Oct 30, 2008.

  1. Nungy

    Nungy New Member

    Oct 30, 2008
    Likes Received:
    Hi all,

    My car stripped 1st gear a couple of weeks ago which a friend of mine replaced but as soon as I took it for a drive it spun the gear again. I noticed the chassis was bent at the engine mounts and was causing the bell housing to angle downwards meaning it couldn't mesh properly. I have fixed the chassis and the bell housing now lines up properly.

    My question is, how do I set it back up so that the bell housing and gears mesh properly. Should the bell housing be meshed into the gears (not tight of course) or does it need to be set up another way.

    Any help would be greatly appreciated.