hi-speed low-speed needle adjustments

Discussion in 'RC General & Getting Started' started by spacin, Jul 15, 2004.

Thread Status:
Not open for further replies.
  1. spacin

    spacin New Member

    Joined:
    Jul 13, 2004
    Messages:
    2
    Likes Received:
    0
    ok i fixed the problem i was haveing , no fuel into carb , i got my new mach.15 engine to start ran for a few then i gave it some throttle and it stalled not to start again, i guess the needles are out of tune and i tryed to return it to the factory settings of .. hs 2 1/2 turns from closed
    ls 4 turns from closed

    but it still wont atart back up
    glow plug is fine

    any ideas?
  2. redheat

    redheat Member

    Joined:
    May 22, 2004
    Messages:
    974
    Likes Received:
    0
    Are you saying that your low speed is 4 turns out ,if so thats way to rich. turn that needle in at least 2 turns in. Go flush on the bottom L/S. That top end could be leaned out also. Make sure fuel is flowing to carb., check filters.
  3. rockn82

    rockn82 Marx Brother

    Joined:
    Nov 6, 2002
    Messages:
    346
    Likes Received:
    0
    Make sure you have no holes in the fuel lines either and also make sure your fuel tank cap is sealing tightly
  4. Bloobert28

    Bloobert28 Member

    Joined:
    Apr 30, 2004
    Messages:
    68
    Likes Received:
    0
    i had the same problem make them flush it works great
Thread Status:
Not open for further replies.