hi all..need hepe

Discussion in 'Tips, Tutorials & Tools' started by yaniv, Nov 15, 2004.

  1. yaniv

    yaniv Active Member

    Joined:
    Nov 6, 2004
    Messages:
    1,087
    Likes Received:
    0
    i have a model in 1/50 and i wont make it to 1/33 in wich size i need to print it

    please

    yaniv
  2. Gil

    Gil Active Member

    Joined:
    Jan 25, 2004
    Messages:
    1,981
    Likes Received:
    0
    Yaniv,

    It needs to be enlarged 50/33 or 1.51 x or 151%.

    Best regards, Gil
  3. yaniv

    yaniv Active Member

    Joined:
    Nov 6, 2004
    Messages:
    1,087
    Likes Received:
    0
    as u say thet..

    if i have a 1/50 model to print it to 1/33 i need to make the print on 151 %
    ?
  4. Leif Oh

    Leif Oh Member

    Joined:
    Jan 27, 2004
    Messages:
    725
    Likes Received:
    0
    Yes, my friend, 151 percent, or perhaps 152 percent.

    But I would advice you not just to adjust the scale in the print menu, but to do the scaling in a graphics programme. Chances are the enlarged 152 percent printout will not fit the paper you are using.

    So you will have to make new print sheets. See article on "Scaling". I hope it helps some.

    Best, Leif
  5. yaniv

    yaniv Active Member

    Joined:
    Nov 6, 2004
    Messages:
    1,087
    Likes Received:
    0
    thenk u vary mach my freand
  6. kk135

    kk135 Member

    Joined:
    Jul 19, 2004
    Messages:
    72
    Likes Received:
    0