E-maxx steering very slow

Discussion in 'RC Offroad Forum' started by curly, Dec 5, 2005.

Thread Status:
Not open for further replies.
  1. curly

    curly New Member

    Joined:
    Dec 5, 2005
    Messages:
    10
    Likes Received:
    0
    The truck turns but it takes about a second before it actually starts to. I've replaced the servo and the servo saver. Any suggestions?
  2. dj6666969

    dj6666969 Active Member

    Joined:
    Feb 6, 2004
    Messages:
    1,284
    Likes Received:
    0
    Try a differen't reciver and see if you have the same problem.
  3. digdug72

    digdug72 Member

    Joined:
    Aug 15, 2004
    Messages:
    176
    Likes Received:
    0
    sounds like reciever
  4. curly

    curly New Member

    Joined:
    Dec 5, 2005
    Messages:
    10
    Likes Received:
    0
    I never would of guessed that. I'll check it out today. As you can tell I'm a little rusty at these. It's been 12 years since working on these.

    Thanks
  5. digdug72

    digdug72 Member

    Joined:
    Aug 15, 2004
    Messages:
    176
    Likes Received:
    0
    I am in the same boat of being out 9yrs, but it's just like riding a bike!!
  6. curly

    curly New Member

    Joined:
    Dec 5, 2005
    Messages:
    10
    Likes Received:
    0
    Would the fact that I was running it outside in 28 degree temps cause this? I was just running it at lunch and it's 35 degrees.
  7. digdug72

    digdug72 Member

    Joined:
    Aug 15, 2004
    Messages:
    176
    Likes Received:
    0
    it might have gotten wet or has dirt inside, is it covered?
  8. curly

    curly New Member

    Joined:
    Dec 5, 2005
    Messages:
    10
    Likes Received:
    0
    It is covered and I do believe it has gotten a little wet.
Thread Status:
Not open for further replies.