This wonderful looking model is available at the usual place (link omitted at designers request) THANK YOU UHU
Chris
This wonderful looking model is available at the usual place (link omitted at designers request) THANK YOU UHU
Chris
Discovery
I think the designer is done with the model now there are 25 pages to download http:// unthinkingly gives the URL despite the clearly posted message about the URL being OMITTED as per designer's request
Thanks for the heads up on 13X gents
Bit of note here...I went to local Hardware store this morning and brought along a sample of page two, to use the members as guides for suitable Diameter Dowel, Got one that I was happy with as you see in Picture 1 but when I attempted to wrap it with the main spine members I got a significant gap as seen in Picture B.
Both pages were printed with same scaling sizes and I have cut as much of the black line off the spine member...any hints or tips?
Thanks in advance
Are you sure the dowel is supposed to fit that snuggly without the wrap? The parts sheet specifies that the dowel should be 9 mm diameter. (Ran the text through Babelfish just to check).