Need help!!!

mxmx995 · 02-01-2004, 01:05 AM

Why can't I start my kyosho ultima gp and have it sit in idle without moving on the ground Like my friends (StreetForce).i know its direct drive & single speed trans. So do i need to buy a different trans or an idle gear or something?? .If so which one whould fit in work.............................thanks[?]

mastmec · 02-01-2004, 02:30 AM

It doesn't have a clutch?

mxmx995 · 02-01-2004, 02:10 PM

ookay but i has a one speed single clutch ,what do i need 2 buy a 2 speed clutch......like this one:http://www2.towerhobbies.com/cgi-bin...?&I=LXT883&P=7

mastmec · 02-01-2004, 02:17 PM

Sounds like you first need to check your clutch, the bearings and spring. loosen the engine so it will seperate from the spur, spin the clutch it should have no friction and should spin freely. For the two speed clutch bell you would also have to have the two speed spur gears and clutch assy. if it offered for that car, I'm not sure.

mxmx995 · 02-01-2004, 11:30 PM

ok when i spin it it has a lot of friction in dosen;t spin freely it's tight

dudex · 02-01-2004, 11:38 PM

you need to replace the bearings probably. open it up and check if theres a lot of dirt or if somethings broken.

02-01-2004, 01:05 AM	#1
mxmx995 Junior Member Join Date: Dec 2003 Location: . Posts: 16	Need help!!! Why can't I start my kyosho ultima gp and have it sit in idle without moving on the ground Like my friends (StreetForce).i know its direct drive & single speed trans. So do i need to buy a different trans or an idle gear or something?? .If so which one whould fit in work.............................thanks[?]

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

02-01-2004, 02:30 AM	#2
mastmec Senior Member Join Date: Jan 2004 Location: TX. Posts: 681	It doesn't have a clutch?

02-01-2004, 02:10 PM	#3
mxmx995 Junior Member Join Date: Dec 2003 Location: . Posts: 16	ookay but i has a one speed single clutch ,what do i need 2 buy a 2 speed clutch......like this one:http://www2.towerhobbies.com/cgi-bin...?&I=LXT883&P=7

02-01-2004, 02:17 PM	#4
mastmec Senior Member Join Date: Jan 2004 Location: TX. Posts: 681	Sounds like you first need to check your clutch, the bearings and spring. loosen the engine so it will seperate from the spur, spin the clutch it should have no friction and should spin freely. For the two speed clutch bell you would also have to have the two speed spur gears and clutch assy. if it offered for that car, I'm not sure.

02-01-2004, 11:30 PM	#5
mxmx995 Junior Member Join Date: Dec 2003 Location: . Posts: 16	ok when i spin it it has a lot of friction in dosen;t spin freely it's tight

02-01-2004, 11:38 PM	#6
dudex Senior Member Join Date: Jan 2004 Location: . Posts: 182	you need to replace the bearings probably. open it up and check if theres a lot of dirt or if somethings broken.