|11-08-2006, 02:00 PM||#1|
Join Date: Oct 2005
Location: Troy MI
Some decoder installation specifics?
I'm looking to cross a bridge I will not even come to until March of next year...
I preordered two D&M Altas C425's. The Digitrax decoder DH163IP was recommended, so I ordered two of those. I was told the hardest part of the install would be getting the shell off (implying the decoder plug-in was a piece of cake)
Is this true?
Do all of you think this decoder is a good match for the loco? Maybe I should try to get one with a speaker? I will probably still be using my Bachmann EZ Commander which cannot program CV's... This has not been a problem so far... but will I like the factory speed settings of this decoder as much a the "Equipped" dual mode decoders I am used too?
What about directional lighting, will I hafta solder those wires in?
Help a guy who is new at this...
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.
Modelling the D&M
|Thread||Thread Starter||Forum||Replies||Last Post|
|Decoder installation ?||robgoo||DCC & Electronics||8||02-13-2006 10:55 PM|
|DCC Decoder installation!||Freelancer||FAQs||13||01-21-2006 04:28 AM|
|atlas n gp-38 decoder installation||rksstl||DCC & Electronics||6||01-03-2005 08:15 PM|
|LL GP9RM Decoder Installation||Agatheron||FAQs||8||12-16-2003 06:06 PM|
|Decoder Installation||cascadescyclist||N / Z Scale Model Trains||1||11-18-2003 05:39 PM|